Steel Bending | Barbados Vocational Training Board

Air Conditioning and Refrigeration

Participants are trained in the field of Air-conditioning and Refrigeration to install, repair and service domestic and semi-commercial systems.

Download the Skills Training Programme Air-conditioning and Refrigeration Brochure here.


Latest Course Information

  • Aug 20, 2018

    Duration:
    2 Semesters
    Day(s):
    Monday - Friday
    Time:
    8:00am - 4:00pm
    Tutor:
    Mr. Adrian Prescod

Frequently Asked Questions

Below are a few FAQs pertaining to this programme or course:

  • What do I receive at the end of the programme?

    You will receive a Certificate of Apprenticeship. Note that in order to receive certification persons must have completed both the practical and theoretical aspects of their training programme. Certification is based on attendance, the completion of the skills, tasks and competencies listed in the scheme of training and the submission of relevant records from the employer and the approved academic institution.

  • What time are the classes held?

    Classes are held from 5.30 pm to 8.30 pm.

  • What is the Admissions Policy for the In Plant programme?

    Employers wishing to access training through the In-Plant Programme should communicate the request in writing to the Director of Training. If the programme that the client is interested in is not readily available, a new course is developed for the programme.

View all Questions

Training Centres

This course is held at the following training centre(s):

  • C. Lomer Alleyne Skills Training Centre

    The CLA centre is where most of the Board’s Evening programmes are held. It is known for its Agricultural and Engineering programmes. CLA is the BVTB’s largest centre and it continues to be expanded.

View all Centres

Testimonials

  • Carlos Watson

    The Apprenticeship Programme has been a good experience. I learned a lot at Structural Systems during the on-the-job training. Within three years, I began as an Apprentice Welder and have become an Operator, by gaining experience in welding, fabrication, and by receiving Autocad training. I enjoyed the theoretical training at the Samuel Jackman Prescod Polytechnic. The teachers were helpful and kind, especially Mr. Ian Harvey.

    Carlos Watson

    Machine Operator at Structural Systems Limited

View all Testimonials