Tiling and Decorative Finishes
Not just your ordinary Tiling course! This is an extremely popular programme which teaches participants how to cut and align ceramic tiles in various designs. In addition, participants will also be taught the latest techniques in the application of trowel plastic.
We invite you to use our new Online Application Portal to submit your application to the Barbados Vocational Training Board.
Simply click below and select Barbados Vocational Training Board as your target institution. Then complete the Sign Up form and Submit.
NOTE: Please use a valid email address you can access as you will be required to validate the email address before continuing with the application.
Latest Course Information
-
Sep 21, 2026
Duration:12 Weeks
Day(s):Mondays
Time:5:30pm-8:30pm
Tutor:Mr. Hinds
Course Fee:$390.00
Frequently Asked Questions
Below are a few FAQs pertaining to this programme or course:
-
- What is the cost of each programme?
Only the Evening Programmes have an associated cost. This ranges between $150.00 and $650.00. For information on specific classes, please visit our Evening Programmes section.
-
- How do I become an Apprentice?
Completing an application form gets the process started. After this you must be:
- interviewed by an inspector and a potential host employer
- Accepted by the employer
Persons under 18 years must also be examined by a medical practitioner who will certify that they are fit.
-
- What is the duration of the programmes?
Each programme runs one evening a week for 12 weeks.
Training Centres
This course is held at the following training centre(s):
-
C. Lomer Alleyne Skills Training Centre
The CLA centre is where most of the Board’s Evening programmes are held. It is known for its Agricultural and Engineering programmes. CLA is the BVTB’s largest centre and it continues to be expanded.
Testimonials
-
The Apprenticeship Programme has been a good experience. I learned a lot at Structural Systems during the on-the-job training. Within three years, I began as an Apprentice Welder and have become an Operator, by gaining experience in welding, fabrication, and by receiving Autocad training. I enjoyed the theoretical training at the Samuel Jackman Prescod Polytechnic. The teachers were helpful and kind, especially Mr. Ian Harvey.
Carlos Watson
Machine Operator at Structural Systems Limited
